- Joined
- Jul 4, 2004
Hey everyone!
Thanks for all your help! Now I have my swiftech setup up and running pretty smooth. I had 2 rads, a cpu block and a gpu block, a swiftech fill and bleed and a pump. My question is that my temps are higher w/ water then I had when I was using a sp-94 w/ a enermax fan. Using an abit mobo (temps are off by 10c), I idle at around 50c and load at bout 62c (so 40c and 52c real temps). I have the setup pump-> fill and bleed - rad> cpu -> rad -> gpu -> pump. I am using arctic silver 5 on the cpu. My specs are below..any ideas?? Thanks!
-Jason
Abit IC7-Max 3 Mobo (bios 15)
P4 3.0C running a 3.4Ghz (fsb 227, vcore 1.65v)
1gb ocz pc4000 ram (2.8v)
Thanks for all your help! Now I have my swiftech setup up and running pretty smooth. I had 2 rads, a cpu block and a gpu block, a swiftech fill and bleed and a pump. My question is that my temps are higher w/ water then I had when I was using a sp-94 w/ a enermax fan. Using an abit mobo (temps are off by 10c), I idle at around 50c and load at bout 62c (so 40c and 52c real temps). I have the setup pump-> fill and bleed - rad> cpu -> rad -> gpu -> pump. I am using arctic silver 5 on the cpu. My specs are below..any ideas?? Thanks!
-Jason
Abit IC7-Max 3 Mobo (bios 15)
P4 3.0C running a 3.4Ghz (fsb 227, vcore 1.65v)
1gb ocz pc4000 ram (2.8v)