cpu problem...

[dj_unforgetable]

Here it is...i have am amd t-bird 1gig AXIA "Y" right, but when i went into BIOS and increased the multiplier from 7.5 to 8, i restarted it like you have to, but then it didn't boot. I had to reset the cmos in order for everything to go back to normal...whats up with that? Is the problem the L1 bridges?

[Jon]

Sounds like it.

Check your connection on them and try again.

[dj_unforgetable]

Also, i had a 1gig chip b4, before i fried it, and when it was overclocked to 1.4 gigs' idle ot was 51C load probably 54C, but now when i put this same new chip in (1gig), not overclocking it, in Asus Probe, i get a temp of 55C idle and 59C load...whats up with that?

[TranceBear]

I do not have the asus probe but I have seen posts that say they read like 10c higher than it should

[dj_unforgetable]

Is there any program that CAN read my CPU temps CORRECTLY???If so, what is the name of the prog, and if possible a link to it, thnx

[!-=sky=-!]

well.......i m using a program called vcool

it's quite accurate in my opinion

find it on www.tweakfiles.com <--i think..if not search of it somewhere

[eobard]

Or you can use SiSoft Sandra, available at:http://www.sisoftware.co.uk/sandra, or Motherboard Monitor from: http://mbm.livewiredev.com/.

:)

[Da Whip]

I found the site for Vcool;
http://www.naggelgames.de/vcool/VCool.html[/URL]