First attempt was botched, second any good?
My first attempt at setting up a WC system was pretty horrible so I've decided to give it a second try. This time the routing will be quite different. Anyway, check it out.
The idea is to allow better bleeding, improve the noise levels and to improve the temperatures of the case and CPU/GPU. The placement of the rad trapped a lot of bubbles and it was just too much of a hassle to get them out.
The main thing that I'm worried about is the placement of the bay reservoir. I was thinking that the reservoir might be too restrictive and cause adversary performance. My current setup is comprised of an MCP600, Dual heater core, 5.25" bay res, MCW6002, and a Maze 4 GPU block.
Do you think that this would be a good idea? Oh, forgot to ask; Do you think that I should place the two 120mm fans pulling or pushing? (I'm going for decent case temperatures too)
My first attempt at setting up a WC system was pretty horrible so I've decided to give it a second try. This time the routing will be quite different. Anyway, check it out.
The idea is to allow better bleeding, improve the noise levels and to improve the temperatures of the case and CPU/GPU. The placement of the rad trapped a lot of bubbles and it was just too much of a hassle to get them out.
The main thing that I'm worried about is the placement of the bay reservoir. I was thinking that the reservoir might be too restrictive and cause adversary performance. My current setup is comprised of an MCP600, Dual heater core, 5.25" bay res, MCW6002, and a Maze 4 GPU block.
Do you think that this would be a good idea? Oh, forgot to ask; Do you think that I should place the two 120mm fans pulling or pushing? (I'm going for decent case temperatures too)
Last edited: