TDX Block on ABIT AI7

How would you go about mounting a TDX on an ABIT A17. Would you remove the bracket and mount it that way? Im having trouble removing that bracket if that is the case. Any suggestions? I thought that there would be mounting holes on the motherboard.

The 4 mounting holes are there, but the stock retaining bracket uses them. You need to pull the little center pins out first. Pry them up with a jewelers screwdriver or carefully push them through from the back. Don't slip and mess up the mobnce the center pins (usually white) are out, the bracket should pop out.

What i did was that i used a plier to squeeze the black stuff out and then took the white out. Thanks a lot though, took me a while to figure it out.