- Joined
- Mar 18, 2002
- Location
- The Parabolic Quantum Well
In my haste to get my computer up ASAP so I can start gettin in on some Doom 3 action, I acidentally sized a section of tubing, and now I can't put on the side panel of my case without causing a kink in the line.
I already filled the system with water, and my system is up an running so it's no long a simple matter of disconnecting the hose and cutting a little bit off.
I was wondering if anybody ever done this before, or have any ideas on how I can remove a small section of tubing without having to drain the system.
I was thinking of cutting a small peice of where it is connected to the barbs and slide the hose in more after I take that piece off, but I did a dry run on a spare bard and hose I had with a knife and it seems like this would be pretty difficult to do.
Does anybody have any other ideas, or know any tools I can use to do this? Thanks.
I already filled the system with water, and my system is up an running so it's no long a simple matter of disconnecting the hose and cutting a little bit off.
I was wondering if anybody ever done this before, or have any ideas on how I can remove a small section of tubing without having to drain the system.
I was thinking of cutting a small peice of where it is connected to the barbs and slide the hose in more after I take that piece off, but I did a dry run on a spare bard and hose I had with a knife and it seems like this would be pretty difficult to do.
Does anybody have any other ideas, or know any tools I can use to do this? Thanks.