Is this good enough?

[nolan_3d]

Cooler Master DP5-6131A
L60 x W60 x H41 (mm)

FAN Dimensions 60 X 60 X 13 mm
Rated Voltage 12 VDC
Rated Speed 5400 R.P.M.
Air Flow 27.72 CFM
Noise Level 38 dB(A)

It has the stock Aluminium HS and the HS is about twice as thick as the fan and the same width and length.

Is it good enough for my Duron 800 @ 1000 until I go water cooled?

[gouki]

Swiftech MCX-370, SK-6, Millenium Glaciator maybe ?

[nolan_3d]

Well, I'm not buying another HSF if I can help it, this came with the duron when I bought it. I am going to do water cooling with a block I designed. http://forums.overclockers.ws/vb/showthread.php?s=&threadid=31788&highlight=home

[TranceBear]

I would not overclock with the stock heatsink at all. It just does not have the ability to cool it enough. Heck I would noy even use the stock one for stock speeds, but it will do fine until you change your setup. Just please watch your temps if you still insist on O/Cin with it.

[nolan_3d]

Well since I have vcool installed my idle temp is around 31-33º, but my load temp gets up to between 58-64º and I know that is horrible but I rarely load down my processor........it reduces effeciency