Ok, here's my current setup:
And I just got some birthday presents.......so all of that^ ^ is going into this:
Note the crude cardboard shroud on the Bonneville core. I may try to get some plexiglass and cut it with the new dremel.....but I am not "arts & crafts" inclined, so I may mess it all up. I might just end up building a better cardboard shroud and slappng it on there.
So far I've removed the top fan and put the Vantec fan vibration dampener kit on it, removed the grill for the rear exhaust. I'm waiting until I order some PAX MATE to line the inside of the case with, until I do any more work on it. Fry's doesn't carry PAX MATE so I've gotta order online and wait for it
Shroud looking a little better:
The paint isn't a dead-on match, but the whole thing is essentially going to be concealed by the drive bays anyway
I'm trying to figure out the best way to mount my CCFL's. Well, I had two that came in a package, but I didn't notice that one was broken, and I LOST the receipt so I'm kinda stuck. I was thinking about on the bottom, like you can sort of see in the pic above.
Any other ideas on CCFL placement??? Also, since I'm down to one, will that be good enough, or will I need two??? The one is pretty thin...
And I just got some birthday presents.......so all of that^ ^ is going into this:
Note the crude cardboard shroud on the Bonneville core. I may try to get some plexiglass and cut it with the new dremel.....but I am not "arts & crafts" inclined, so I may mess it all up. I might just end up building a better cardboard shroud and slappng it on there.
So far I've removed the top fan and put the Vantec fan vibration dampener kit on it, removed the grill for the rear exhaust. I'm waiting until I order some PAX MATE to line the inside of the case with, until I do any more work on it. Fry's doesn't carry PAX MATE so I've gotta order online and wait for it
Shroud looking a little better:
The paint isn't a dead-on match, but the whole thing is essentially going to be concealed by the drive bays anyway
I'm trying to figure out the best way to mount my CCFL's. Well, I had two that came in a package, but I didn't notice that one was broken, and I LOST the receipt so I'm kinda stuck. I was thinking about on the bottom, like you can sort of see in the pic above.
Any other ideas on CCFL placement??? Also, since I'm down to one, will that be good enough, or will I need two??? The one is pretty thin...