Hello all, briefly my system specs:
-P4 3.0 HT, 800fsb
-Asus P4c800e deluxe
-2x512mb (in dual channel slots) corsair 400mhz pc3200 ram
-Ati radeon x800 pro soft modded to x800 XT PE 16 pipe and vga silencer rev4
-450 watt PS
-2x Maxtor 80 gig on raid setup
-40 gig wd
-60 gig wd
-plextor 708a 8x dvd burner
-lite-on 16x dvd rom
-SB audigy gamer sound card.
Here are my overclock settings: (thanks to Vflux for these)
- CPUID Maximum Limit [Disabled]- Hyperthreading [Enabled]- Configure DRAM by SPD [3-4-4-8] Burst Length [8]- Performance Acceleration Mode [Auto]- DRAM Idle Timer [Auto]- DRAM Refresh Rate [Auto]- Spread Spectrum [Disabled]- ICH Delayed Transaction [Disabled]- MPS Revision [1.4]- Graphic Apapter Priority [AGP/PCI]- Graphic Aperture Size [128MB]
- AI Overclocking Tuner [Manual]- CPU External Frequency [230]- DRAM Frequency [400]- AGP/PCI Frequency [66/33]- CPU Vcore Voltage [1.6V]- DDR Reference Voltage [2.85V]- AGP VDDQ Voltage [1.65V]- Performance Mode [Standard]- USB 2.0 Controller [2]- USB Legacy Support [Disabled]- Parallel Port/Serial Port [Disabled]- Allocate IRQ to PCI VGA [No]- Speech Reporter [Disabled]<BR>- System Thermal [Disabled]- Q-Fan [Disabled]- Onboard LAN [Enabled]- All Onboard Devices [Disabled]- IDE Detect Time [0sec]<BR>- 32bit Data Transfer [Enabled]
And my question is what ratio should i be having my Ram at...i dont really understand what 1:1 means etc. I just added the zalman HS to my CPU...and my system is stable at the above settings...PCU never gets hotter than 51 degrees C. Id like to make sure that im getting all i can out of the system. I think i have a ram issue because when i have a few programs running at once..i can press ctrl+alt+del and that utility says im only using 5-20% of my CPU...but my pc acts extremly sluggish. Anyone have any ideas? Or any settings i should change? Thanks a ton in advance!
-P4 3.0 HT, 800fsb
-Asus P4c800e deluxe
-2x512mb (in dual channel slots) corsair 400mhz pc3200 ram
-Ati radeon x800 pro soft modded to x800 XT PE 16 pipe and vga silencer rev4
-450 watt PS
-2x Maxtor 80 gig on raid setup
-40 gig wd
-60 gig wd
-plextor 708a 8x dvd burner
-lite-on 16x dvd rom
-SB audigy gamer sound card.
Here are my overclock settings: (thanks to Vflux for these)
- CPUID Maximum Limit [Disabled]- Hyperthreading [Enabled]- Configure DRAM by SPD [3-4-4-8] Burst Length [8]- Performance Acceleration Mode [Auto]- DRAM Idle Timer [Auto]- DRAM Refresh Rate [Auto]- Spread Spectrum [Disabled]- ICH Delayed Transaction [Disabled]- MPS Revision [1.4]- Graphic Apapter Priority [AGP/PCI]- Graphic Aperture Size [128MB]
- AI Overclocking Tuner [Manual]- CPU External Frequency [230]- DRAM Frequency [400]- AGP/PCI Frequency [66/33]- CPU Vcore Voltage [1.6V]- DDR Reference Voltage [2.85V]- AGP VDDQ Voltage [1.65V]- Performance Mode [Standard]- USB 2.0 Controller [2]- USB Legacy Support [Disabled]- Parallel Port/Serial Port [Disabled]- Allocate IRQ to PCI VGA [No]- Speech Reporter [Disabled]<BR>- System Thermal [Disabled]- Q-Fan [Disabled]- Onboard LAN [Enabled]- All Onboard Devices [Disabled]- IDE Detect Time [0sec]<BR>- 32bit Data Transfer [Enabled]
And my question is what ratio should i be having my Ram at...i dont really understand what 1:1 means etc. I just added the zalman HS to my CPU...and my system is stable at the above settings...PCU never gets hotter than 51 degrees C. Id like to make sure that im getting all i can out of the system. I think i have a ram issue because when i have a few programs running at once..i can press ctrl+alt+del and that utility says im only using 5-20% of my CPU...but my pc acts extremly sluggish. Anyone have any ideas? Or any settings i should change? Thanks a ton in advance!