My buddy just got the A64 3000/Chaintech popular setup along with some ocz 3200 premier ram.....
In the Chaintech bios, under DRAM configuration, 4 options for the mem ratio are given: Auto, 100, 133, 166
It is said that on these boards, if you set the Dram ratio to "auto", it's a 1:1 ratio so long as your HTT is above 4x....
However, when set to this, and the cpu overlock (HTT) are set to 200 (DDR 400 when ran 1:1), it boots up at a 5/6 ratio (ram @ 166)
What's going on?
Also...the HT isn't locked above 10x on this board?? It goes to 20x?
I double checked to make sure HTT was set to 4x...all is good...
What's going on!?
In the Chaintech bios, under DRAM configuration, 4 options for the mem ratio are given: Auto, 100, 133, 166
It is said that on these boards, if you set the Dram ratio to "auto", it's a 1:1 ratio so long as your HTT is above 4x....
However, when set to this, and the cpu overlock (HTT) are set to 200 (DDR 400 when ran 1:1), it boots up at a 5/6 ratio (ram @ 166)
What's going on?
Also...the HT isn't locked above 10x on this board?? It goes to 20x?
I double checked to make sure HTT was set to 4x...all is good...
What's going on!?