Voltages on OCed FC Celeron

[Stanman]

Could I get a few responses on what voltages people are running on their oc fc cellery? :o

[Phil]

cCO celeron 600@927mhz with 1.7v and cooled by a glaciator and 4 30 cfm case fans.

If you are overclocking one your self then stick under 1.9v with the default intel cooler and don't exceed 2.1v unless you use a peltier, 2v is the most I would recomend using and only with good cooling

[Pinky]

The newer celerons, 800mhz and up on 100fsb (the cD0 chips especially) don't need much of a voltage increase to get 30+ percent gains. I overclocked an 800 celeron to 1.18 recently at default (1.75) voltage and stock/retail heatsink/fan. Your results may vary.

[Ebola]

1.75~1.8v on a 566 cbo @ 952

[wilbo666]

c 600 @ 1008 (1.7, defult)
c 800 @ 1066 (1.7 defult, maxed out my old bx board so I can't get the chip higher on my board... :-(

Wilbo

[JaY_III]

cBo celeron 633 that will do 1000 air cooled @ 1.9 Volts
2.1 will push it to 1066 watercooled

tried 2.3 and fried my motherboard... had to replace some capasitors to fix it.

[Lancelot]

800 to 1056 @ 1.85V

[jays]

800-->1066 @ 1.7(Default) Voltage

[Sklathill]

633 to 950 at 1.825 with the Zalman. It runs at a gig easily with a bit more voltage (1.85) and a Glaciator on it. I like the quiet of the Zalman, though, and I guess you need to do some extra stuff with the ST6 to pop in more voltage...

[The Doors]

Celeron 2 600 cB0 @907Mhz 1.85v with a Pep66XL Sanyo-Denki/Delta38 + ArticSilver II and 5 Sunon's fans to cool the case (Intake 1x80 & 2x92mm, Exhaust 1x120 & 1x80mm).

[Monaco]

566 cC0 to 993 with a FOP-32 and 1.92 volts- won't go any higher and I'm afraid to bump voltage more...

Ususally run at 975 just to be safe.

[LutaWicasa]

Old Cbo, 1.95 v.