PDA

View Full Version : Vantec FCE-6254OD

ILOVEAMD
09-04-01, 05:20 PM
I bought this cooler and a copper shim. I am running at slightly over 100 degrees celcius and it is pimp.
Ingo
09-04-01, 09:33 PM
What? Over 100ºC? No, you're not! You mean 100ºF, don't you?
ILOVEAMD
09-04-01, 10:29 PM
yes
Crazy Jayhawk
09-05-01, 12:10 AM
*whew*

You had me worried with that 100ºC figure. o.O
TranceBear
09-05-01, 04:36 AM
That was my 1st heatsink, I loved it!! This thing took me to 1466mhz. But why the shim with this one? This IS the easiest heatsink to remove and install. I would take it off if you ever remove it again. Good choice
Ingo
09-05-01, 08:30 AM
Originally posted by TranceBear
That was my 1st heatsink, I loved it!! This thing took me to 1466mhz. But why the shim with this one? This IS the easiest heatsink to remove and install. I would take it off if you ever remove it again. Good choice I agree. The FC62540D was also my first heatsink and got my AXIA 1.2 to 1.466 as well:) . One thing I do recommend if you like to hear anything besides that screaming Delta while working is to wire in a Rheostat. I turned mine down to 6k from the stock 7.3k and it raised the temp 1ºC, but really reduced the fan noise considerably. I'm guessing effectively 10v and 30/31 CFM.
TranceBear
09-05-01, 01:28 PM
Or do the 7 volt mod on that little Delta.
The Overclocker
09-05-01, 01:35 PM
looking at this i might buy this cooler, but i have just made my own water block so bye...