6800nu Volt Mod

[Droban]

So I think I modded my bios correctly but I'm not sure since I still get artifacts when I enable 16 pipes. Is there anyway to see if I actually modded the bios correctly?

[Flip-Mode]

There isn't, but if you are getting the artis after you modded to 1.4 and enabled the 16 pipes then the last 4 are bad 100%. Sorry, I got the same problem.

BTW
My card is a great overclocker with the 1.4 V mod, might try 1.5 and get even higher.

[dukat]

mh, this is off topic, but u guys seam to have some experience with bios modding? :burn:
i have the following problem, when i open my bios with omniextreme the 3D speed is already set to 1.4V! does this mean that the card is already runnig at 1.4V? what was yours set at?

heres a pic:
http://img.photobucket.com/albums/v347/dukatenscheisser/Unbenannt.jpg

[Droban]

Well I am kind of new to this, but I'm pretty sure you have to change the throttle to 1.4v.

[Droban]

What does it say in the dos mode after you flash it correctly?

[dukat]

i havent flashed it yet, only did the backup and opened it with omniextreme.

[Flip-Mode]

I turned all three options to 1.4V for it to work best.

[dukat]

ok, but what were the default settings? was the 3d voltage set to 1.4V ,too?

[Flip-Mode]

Ok I checked the old Bios backup I have:
3d - 1.4V
Thrtl - 1.2V
2D - 1.1V
There ya go.

[dukat]

thank you :)

EDIT: i have downloaded some 6800nu bioses from mvktech and they all have 3d set to 1.4V.