- Joined
- Oct 2, 2004
- Location
- Rockland New York
Posts but won't load Windows
working on an old system HP 8650 , 533 Celeron(total speed not FSB) waiting for a 1.1 Celeron upgrade no AGP,
I installed a ATI 7500 64 meg PCI card and it posts to the HP screen (Post mask) and hangs there, when I try to enter bios it says entering setup on the HP screen and then nothing. Anybody have some experience with this I used to have his card on an old Compaq without AGP that was actually six months older than this system.
When I switched the monitor cable, nothing When I remove the card it boots up normally, if the card was dead it wouldn't even Display rite? Also the system is running at 66 FSB. Any ideas?
working on an old system HP 8650 , 533 Celeron(total speed not FSB) waiting for a 1.1 Celeron upgrade no AGP,
I installed a ATI 7500 64 meg PCI card and it posts to the HP screen (Post mask) and hangs there, when I try to enter bios it says entering setup on the HP screen and then nothing. Anybody have some experience with this I used to have his card on an old Compaq without AGP that was actually six months older than this system.
When I switched the monitor cable, nothing When I remove the card it boots up normally, if the card was dead it wouldn't even Display rite? Also the system is running at 66 FSB. Any ideas?
Last edited: