Cheap hole saw? [Archive] - Overclockers Forums

Mortis03

11-01-04, 01:49 AM

I'm looking for a cheap hole saw to make a 120 mm blow hole. I found a few on froogle for like 30 bucks, but that is a little bit too expensive for me. Does anyone know of where I might be able to find one for cheaper? Thanks

crimedog

11-01-04, 02:15 AM

Get a power drill (if you don't have one already) because they're very good to have.

Hole saws attachments at home depot are very cheap.

Mortis03

11-01-04, 02:38 AM

I have a couple decent drills. I'll go by home depot this week maybe.

wannaoc

11-01-04, 12:17 PM

If I remember right its the 4 1/2" saw to do 120mm fans. It should run you about $20.00 or so.

Permanoob

11-01-04, 01:04 PM

A couple of weeks ago the cheapest 120mm hole saw was $35.

I just bought a $6 pack of dremel cutting discs and did the job by hand.

Mortis03

11-01-04, 04:13 PM

A couple of weeks ago the cheapest 120mm hole saw was $35.

I just bought a $6 pack of dremel cutting discs and did the job by hand.

My case is a beast, thickest sides/top i've seen. I tried a dremel for the windows and it would eat a disc in about 1-2 cms. I gave up on that and used a jigsaw.