- Joined
- May 28, 2004
I got my stacker case this weekend, and began installing my H20 parts ASAP. I bought a dual 120MM HC from VoyeurMods, thinking it was gonna fit in the drive cages...to my dismay it was about 1/2" too big so I couldn't get it to fit.
Now, I got my old DTEK ProCore to fit in, but I really had to apply a little force. It bent the side of the rad a little, mostly from the drive cage notches squeezing in. I removed the HC and ran some alcohol thru it, and noticed no leaks. I also blew air into it, which it flowed freely out the other barb. Did I do serious damage by bending the sides a bit? Could I have damaged the flow?
Also, until I can find a dual HC that will fit, do you guys think that the single 120MM ProCore can cool my FX-55 and X800XT-PE effectively? I've got 2 evercool fans on it in a push / pull.
Sorry for the length
Now, I got my old DTEK ProCore to fit in, but I really had to apply a little force. It bent the side of the rad a little, mostly from the drive cage notches squeezing in. I removed the HC and ran some alcohol thru it, and noticed no leaks. I also blew air into it, which it flowed freely out the other barb. Did I do serious damage by bending the sides a bit? Could I have damaged the flow?
Also, until I can find a dual HC that will fit, do you guys think that the single 120MM ProCore can cool my FX-55 and X800XT-PE effectively? I've got 2 evercool fans on it in a push / pull.
Sorry for the length