the only two options that should be considered are the fedco 2-302 and the fedco 2-342. The 2-302 is taller but skinnier, and the 2-342 is shorter but wider. They dont vary that much, only 1-2 inches max each way. They preform about the same, its just a matter of which would be more convienent. Neither is smaller than the other, about the same surface area, just depends on which would fit in your case better.
are these better than a dual BIX, besides the huge price difference? also are these copper or aluminum or what? i like the position of the fedco 2-342 barbs for what im planning on in my setup. Would a MCP600 be strong enough for one of the afore mentioned cores, a TDX, fuzion HL or MAze4 and POSSIbly and chipset block?
edit - ill be using 4 sanyo denkis(the ones in the classifieds section) on a fan controller.
Seems like they are right at 23 inches, but I think I have about 1/2 inch gap between the two of them. I will be out there later tonight working, and get you an actual measurement.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.