NPT? Whats that? Usually i noticed that Swiftech says 1/2", they mean 1/2" barbed and 3/8" threaded. So i assume that dangerden also uses 3/8" threaded and 1/2" barbed
1/4" National Pipe Thread. The Inner Diameter of a fitting using 1/4" NPT is slightly less than 1/2" because of the wall thickness. The only way to get true 1/2" ID fittings is to use 5/8" OD. Hope this cleared some things up.
Tube fittings with an o-ring are not compatable with NPT fittings because they are not tapered. They rely on the o ring for a good seal. If these "high flow" fittings (marketing gimmick) use an o-ring to seal or if the maze-4 is intended to use o-rings for sealing and you are using NPT barbs, you wont have a compatable setup.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.