Diamond Viper TNT2U

[Killer Chef]

Hi All,

I have a Viper TNT2 Ultra on an AX34PROII runnign a celeron2 850@1020, In quake 2 timedemo 1 i can only manage 140ish fps @ 640x480......I have disabled V-Sync and have also enabled AGP4X both on the Mobo and the Vid card.and still get low FPS...any ideas?
Also a friend of mine has a PIII600e@800 and using my vid card was able to get over 200fps at the same settings (previously)...

aaaaand.......When I run CPUZ it is saying that the transfer rate is still at AGP 2X....whats up with that?

My system..
AX34PROII
celeron 2 850@1020
SBLive!
256mb PC133

[Zuck Gou :)]

Sounds to me like your CPU is holding you back at 640x480 since it's a low resolution.

A TNT2U is still fine for most games though. Try a newer engine(q3?) and see what kind of frames you get.

Other than that I'd suggest the newest drivers that just came out.

Good luck