- Joined
- Apr 19, 2003
So, I just got the main stuff I need.
I got the CPUs, and I got the board, K7d MAster L, rev 1, then one of the important numbers present a few times on the thing is "030"
Anyhow, so I slip the 2x barton mobile 2600+s that were previously in some other guy's k7d L, that was pin modded.. and it gives me a beep code of this:
HIGH low HIGH low HIGH low HIGH low
continously, and I can't figure out what it is. PSU is connected, j4 power is connected, I bought some cheapy heatsinks at BB to hold me off, but they're sufficient for stock... I have a cheapy vidcard on there, and 2x 256 MB pc3200 Hyperx for right now.
Anyone got any ideas? The guy said he didn't have ot do any additional mods to the proc itsself before they worked in HIS, and from what I read they should work on 030 rev or greater or summit. I'm completely stumped, do I have to cut some bridges or what? :/
Lemme know, thanks.
-Excelsior
I got the CPUs, and I got the board, K7d MAster L, rev 1, then one of the important numbers present a few times on the thing is "030"
Anyhow, so I slip the 2x barton mobile 2600+s that were previously in some other guy's k7d L, that was pin modded.. and it gives me a beep code of this:
HIGH low HIGH low HIGH low HIGH low
continously, and I can't figure out what it is. PSU is connected, j4 power is connected, I bought some cheapy heatsinks at BB to hold me off, but they're sufficient for stock... I have a cheapy vidcard on there, and 2x 256 MB pc3200 Hyperx for right now.
Anyone got any ideas? The guy said he didn't have ot do any additional mods to the proc itsself before they worked in HIS, and from what I read they should work on 030 rev or greater or summit. I'm completely stumped, do I have to cut some bridges or what? :/
Lemme know, thanks.
-Excelsior