GF3. What are standard core, and mem timings?

[killem1x1]

I'm trying to run 3dmark. I can run seti, prime95, and F@H, at the same time with no problems, and my temps stay under 115f/46c, but When I run 3dmark it goes to the first "test" screen,(where it says car detail, etc..), and then drops back out to windows. I lowered my mem/core to 225/465 to see if that helps and it doesn't. Can someone please tell me what the "default" is, and if you have any suggestions on what could be causing my problem. Thanks in Advance!!!
Oh, epox 8k7a+ runing in RAID 0, 140x11.5@2.1v

[-=UR=- Ranger]

What PSU are you running?

[fuzzba11]

Defaults are 200/460, your core is way high

[killem1x1]

Originally posted by -=UR=- Ranger
What PSU are you running?
I'm using a POWMAX LP-6100X Series PSU. I hav three of them, and haven' had any problems out of them before. My 5v line doesn't srrm to drop below 4.95.

[killem1x1]

Originally posted by fuzzba11
Defaults are 200/460, your core is way high
...and what would be reasonable #'s when overclocking this card? It's a Visiontek GF3.

[fuzzba11]

Actually, it depends on each unique card...I've only managed 225/515 with my Hercules, before I start getting errors in 3DMark2001. You probably want to start at around 220/510, test, put one up, test, put other one up, etc.