Hit 1644Mhz with phase change!

[ptcg]

Well, A while back I had a water-cooled rig.. I had made a voltage mod to try to push the CPU to the limits.. With just water, I wasn't able to get very far.. (1350Mhz)

I wanted the setup portable, so I re-did it with the phase change setup I have now... During all the changing back & forth, and various mods, I had disconnected the voltage mod.. I decided since I got it running stable at 1584Mhz @ 1.85V I'd reconnect the voltage mod & see what it could give me...

I had to bring it up to 2.11V (at least, that's what Sandra says.. I have 1.92V in the BIOS), but I got it stable @ 1644Mhz now!! (11.5 x 143)

The cpu temp went from 11C up to 19C (under 100% load), but hey, I can handle that!

[mEKbOY]

Nice work... its good to see some people doing this. That ship you have must be a dog. With that setup you should try to get some extreme results. Look into ayjha "Y" 1.4ghz cpu.. You might get some realy high speeds.

[The Coolest]

I don't understand what exactly did u do?

[mEKbOY]

Phase change.. IE the use of an evaporater..etc

[Warlord2]

that must be a bad chip you should be able to hit 1.6 without the need for a voltage mod

[ptcg]

The CPU I have in it right now is an AXIA.. not sure if it's a 9 or a Y (I forget).. I'm still waiting for a replacement AYHJA.. Mine was defective.. wouldn't boot at all..

The coolest -> I put a small refrigeration unit on my PC to directly cool the CPU.. Check my website for details..