Help me with my Overclock?

[sirjinx1974]

I just went and bought the DFI NF3 Lanparty 250 gig UT and a Athlon64 3000+. :santa: I put it together and it f-ing rocks. The question is, I set my Dram frequency set MHZ to (140 Dram/FSB: 7/10 and I changed my FSB Bus frequency to 238 and I am now running at 2.38GHZ. :cool: Do I have to increase the CPU volt any or is it good what it is set at?

Is it good to plug my 2 raptor drives into the SATA 1-2 or Sata 3-4? Also, when windows asks me for the raid drivers and I push F6, which drivers should I use? Windows gives me 2 options, Raid drivers or Mass storage controller.

[thelopper]

I am not sure about your raid problem, but if you want to overclock above 240 mhz on that board you have to move the SATA to 3 and 4. If you can run stable at that mhz then you don't have to raise the voltage. Hope this helps you.