Sklathill
09-28-01, 02:05 PM
Well, I decided I want to experiment with this thing, so I'm going to jump in and order it, it being the centrifugal blower you see at this page (http://www.grainger.com/Grainger/productdetail.jsp?xi=xi&ItemId=1611630889) .
FOr the outlet dimensions, it says 3 inches (about 76 mms), but how do the mounting holes correspond? I was thinking about mounting this thing below the psu on my Lian Li PC-82. Would by some miracle the holes line up with those on my current 80 mm fan opening there? Will I be doing some cutting? Or will it just not fit in such a configuration? (I'm thinking about mounting it such that the outlet is on the bottom, the intake on the left side if looking at the computer from the back.
FOr the outlet dimensions, it says 3 inches (about 76 mms), but how do the mounting holes correspond? I was thinking about mounting this thing below the psu on my Lian Li PC-82. Would by some miracle the holes line up with those on my current 80 mm fan opening there? Will I be doing some cutting? Or will it just not fit in such a configuration? (I'm thinking about mounting it such that the outlet is on the bottom, the intake on the left side if looking at the computer from the back.