I'm modding my MCP350

[mysterfix]

Hi everyone,

I decided to do the flow mod that was mentioned in a sticky about the best watercooling parts. So far I have gotten the thing all drilled out, fittngs cut and epoxy applied. I am waiting for the epoxy to cure before I can put it all back together and test it. I will post pics soon, test results will have to wait till tommorrow (epoxy takes a long time to dry).

Sorry about the first two pics my auto focus wasn't working for some reason.

[outhouse]

good luck i may do that soon as well

[zip22]

why cant someone produce a new top for it? or why cant the company make a new improved model?

[itchy5]

cant wait to see it :P

[mysterfix]

Pics are up and this thing is definitely pumping alot more water! My temps have dropped about 4-5 degrees under load. I did not use the plastic epoxy as in the systemcooling mod but instead opted for the 90 second instant epoxy(industrial strength). It says 90 seconds on the container but it still took a few hours to harden completely.