A pic of my WBK 38 Lapped and Polished

[goman]

Jush wanted to show off my WBK 38 polish job ( need to brag on my good work and my WIFE just don't give a Da**) hope you guys dont mind.

[train22]

nice! Had to advertise the pack of cigs didn't ya? lol

[goman]

Originally posted by train22
nice! Had to advertise the pack of cigs didn't ya? lol


This was not intended to be a CIG.. advertisement but I guess if you could tell they were smokes I guess I have a well polished H/S

[train22]

Originally posted by goman



This was not intended to be a CIG.. advertisement but I guess if you could tell they were smokes I guess I have a well polished H/S

exactly, was not intended to punt, just to congrat ya on the kick@$$ job you did!

[el]

what are your temps at close to 1.6ghz?

[goman]

Originally posted by el
what are your temps at close to 1.6ghz?


My idle temp is 36C and load is 51C I hope this to inprove after I get my Artic Silver ( HOPE HOPE )

[train22]

Originally posted by goman



My idle temp is 36C and load is 51C I hope this to inprove after I get my Artic Silver ( HOPE HOPE )

I'm sure you'll knock off at least 5C, usualy there is a 5-8 temp diff between Idle and load, you have twice that.

[el]

temps are high but you have low temps for an air cooled system that high. Have you considered modding it to hold maybe a stronger 80mm fan? I hear it is very simple and not only does it improve cfm to 68 but the high pitch noise is gone from the delta.

delta makes the 68cfm fan but I need to find one cheap.

some other fans are good too and not as loud.

[.. AE 86 ..]

how do u lap the heatsink ?
sorry i just don't understand how to make sure it is flat

[-=UR=- Ranger]

You put some sandpaper on a very flat surface like Glass and then you rub the HS in a figure 8 pattern, to make sure it is grinded equal!