stuck at 1.5..HELP!!!!!

[TweaK-FreaK]

stuck at 1.5(11x137):mad: .........cpu voltage @ 1.85v
ram voltage @ 2.7v

try to set the fsb to 140(next setting) wont post??
both voltages at max but temps seem good.....haven't yet tested if it will run at lower voltage, just maxed the voltage to see what it could do.....

millenium glaciator, 3-80mm exhaust, 1-120mm intake, 2-80mm internal case fans.


cpu temp:

idle: 34
load: 42

anything else I can try???

[!-=sky=-!]

drop multiplier and set the fsb higher.......

[Sonny]

Try & drop the RAM voltage a step down & increase the FSB 1MHz at a time. Sometimes when you max the RAM voltage your RAM will not want to go higher.

[Geobronc]

I had the same problem when I was using the BIOS to set the front bus and multipler. I switched to using the jumbers instead and set my switches to 1.85 volts on CPU core and set the multiplyer to 11.5 and the Front bus set to 133. I am now stable at 1530 which isnt much, but better then 1496 i was stuck at.

[TweaK-FreaK]

ok now instead of 11x137=1507

I'm at 10.5x142=1491


next setting is 146 locks up in bios at this setting......

[Sonny]

Isn't it possible to increase the FSB 1MHz at a time?

[TweaK-FreaK]

nope just certain steps......it kinda sucks but I"m stuck with it....the kk266 has that option but the ka doesn't

[Sonny]

Try the Sandra 2001 Burn-In Wizard & let the memory test loop for as long as possible, a hundred or so, then increase the FSB or you can always try a higher multiplier if temps will allow.

[foxmulder]

I'm also able to go higher with jumpers than in Bios. It's conceivable that you might need more than 1.85 V Core to go higher. Some guys go as high as 2.35V

I would try a lower FSB and higher multipier in oder to see if it's your CPU or something else that's unstable