Ok, I've been getting mixed answers throughout the forum.
I'm going to be recieving the rest of my watercooling parts by Monday or Tuesday. My question is, where do I put the T-Line?
I would think at the very top, so all of the air rises out. But, I also heard that the T-Line should be right near the pump, so it doesn't run dry. Then again, I can fill up the loop until enough water goes down to the pump, which will be at the bottom of my case.
So, where exactly do I put the T-Line? Right near the "out"/"in" tubing from the waterblock for the CPU, since that will be the top. But it might also be hard to fill there.
Any suggestions welcome, thanks.
I'm going to be recieving the rest of my watercooling parts by Monday or Tuesday. My question is, where do I put the T-Line?
I would think at the very top, so all of the air rises out. But, I also heard that the T-Line should be right near the pump, so it doesn't run dry. Then again, I can fill up the loop until enough water goes down to the pump, which will be at the bottom of my case.
So, where exactly do I put the T-Line? Right near the "out"/"in" tubing from the waterblock for the CPU, since that will be the top. But it might also be hard to fill there.
Any suggestions welcome, thanks.