- Joined
- Oct 10, 2002
I pulled the stock HSF off and installed my new Water setup over the weekend. I had some issues getting the block to seat properly. Everything booted into Bios but temps were 85C and would climb for a bit until it shut down. Finally I got the block to seat properly and the system booted with much better temps. A little water did splash during the swap but I put a fan on it and let it dry for a few hours before trying to boot which it did.The next time I rebooted the system I got the 1 long and 3 short beep code and have been unable to revive it since.
I thought it might be the graphics card so I swapped that but it didnt help.
Any ideas?
I thought it might be the graphics card so I swapped that but it didnt help.
Any ideas?