6002-775 Mounting question

I just got my Swiftech 6002 block and i noticed it has springs for as part of the mounting...

Are there any good threads tjhat are good guides for optimal installation of this block?

Should i turn each Nut 360 and then another 360 and then another.. and so on to ensure equal pressure?

Any tips or suggestions?

i havent used it yet, but i think you so just that, tighten each one equally until it is rightly secured on there...

keep going on the nuts until the stop turning. should only need hand tighten.

As for the pattern, start at a corner, tighten 1 tiwst, go diagonal, 1 twist, go left er right, 1 tiwst, go diagonal, 1 twist, and go left er right, n you should be where you started.

Repeat until the nuts are tight.


Been using it for 2 months, no problems as of yet.