Well, I recieved my pump a few days ago, but it leaks, so I sent out for a replacement ViaAqua 1800. It's due the 1st of June.
Now, I have my heatercore mounted to the back of my case. There are two barbs inside the case, one near the bottom, one near the upper/middle.
Now, the intake (so everyone says) for this pump is the one not on the top, but on the side, horizontal to the ground. For my setup, I was thinking having the pump pull water from the outtake of the waterblock, and push it through the bottom of the heatercore to the top, which will go to the intake of the waterblock, then to the outtake, etc.
So, to do this, I would need to turn the pump upside, lying on the side (the back) in which the cord comes out. This would be easiest, allowing for less turning of the tubing here and there and for less tubing usage.
So my question: Will this ruin the pump?
Now, I have my heatercore mounted to the back of my case. There are two barbs inside the case, one near the bottom, one near the upper/middle.
Now, the intake (so everyone says) for this pump is the one not on the top, but on the side, horizontal to the ground. For my setup, I was thinking having the pump pull water from the outtake of the waterblock, and push it through the bottom of the heatercore to the top, which will go to the intake of the waterblock, then to the outtake, etc.
So, to do this, I would need to turn the pump upside, lying on the side (the back) in which the cord comes out. This would be easiest, allowing for less turning of the tubing here and there and for less tubing usage.
So my question: Will this ruin the pump?