- Joined
- Mar 11, 2001
- Location
- Auburn California
i use 3/8 id tubing. If i do the mod too increase flow and have a 1/2 id inlet and i put a small piece of 1/2" from my gpu too pump will i get the same results as the test. And or i fit 3/8 tubing over the 1/2 barb??
anyone for the bonus round ? if i install a 3/8 barb on the ddc350 instead of the 1/2"
what i see is the test done on a 1/2" res too pump and 3/8 going out. No mention of a flow in a circle.
folks who have done this mod can you shine some light on me
anyone for the bonus round ? if i install a 3/8 barb on the ddc350 instead of the 1/2"
what i see is the test done on a 1/2" res too pump and 3/8 going out. No mention of a flow in a circle.
folks who have done this mod can you shine some light on me