Mounting D-Tek White Water to S939

Currently using my WW on my NF7-S but I'll be buying a S939 board shortly, so I'm going to need the adapter kit for the S939. Here's my question:

I have the WW that looks like the one in this link:
http://www.dtekcustoms.com/index.asp?PageAction=VIEWPROD&ProdID=106

Which looks different than the one in this link:
http://www.dtekcustoms.com/index.asp?PageAction=VIEWPROD&ProdID=137&HS=1

At the bottom of the first page it says: "For other processor applications click Here" which directs you to the 2nd link above.

Are there different WW blocks? If so, can I even use the one I currently have on a S939 board? or would I have to buy a whole other block?

Edit:
Is this all I need:
http://www.dtekcustoms.com/index.asp?PageAction=VIEWPROD&ProdID=145
??

Yes, that is all you need, I was using mine on an NF7-s and used one to adapt to a socket 754 but as you can see there are many mounting hole options and it works perfect

-Milkman

Alright thanks, I was just a little confused by the pictures. I was pretty sure I just needed the adapter but I wanted to make sure.

The 2nd block pic you posted is just like the first block, except with the universal mounting plate bolted to the top. Either the universal, or the Athlon 64 specific adaptor plates will work to adapt your block.

Just take the motherboards retention bracket and flip it over on top of the block and screw it down . Works like a charm and doesn't cost a penny

I'd go with the retention plate over that method. The springs will allow for the right amount of mounting force to be applied.