- Joined
- Jul 15, 2004
- Location
- Loma Linda, CA
Ok, so I recently got a ThemoChill HE120.3, DD Maze 4 Acetal GPU block, 2x MCP655's all brand new and a used Storm G4. Now I know its generally a good practice to rinse even new components before installing them in a WC loop, but I'm not sure what is enough. Is just rinsing with water enough for the new stuff? Or should I use white vinegar or vinegar/salt and soak it then rinse? Or something else?
Also, I'd like to clean the G4 out well, I plan on boiling it in a mix of vinegar/water, was wondering if that has any effect on the fittings sealed to it (not sure what the sealant is). Or perhaps I should get some CLR for it?
Any advice/opinions welcome...
Also, I'd like to clean the G4 out well, I plan on boiling it in a mix of vinegar/water, was wondering if that has any effect on the fittings sealed to it (not sure what the sealant is). Or perhaps I should get some CLR for it?
Any advice/opinions welcome...