- Joined
- Mar 1, 2005
- Location
- CA
I (finally) finished my loop, so here it is in all its ghetto-ness
Components:
Kustom block
19?? Escort heatercore w/ shroud for 2x92mm
Eheim 1048, run submersed
5 gallon bucket reservoir
About 8' 1/2"id-3/4"od Home Depot vinyl tubing + 2 feet POS 1/2"id-5/8"od "kink-for-sure" vinyl
1 3/4" gallon distilled h2o, with a spa biocide tablet
Lotsa hoseclamps, zipties, ~1 1/2 tubes 5 minute epoxy, some amount of my blood and sweat
Now for the pics:
Completely kustom block:
Inside with impingement center inlet and 2 outlets
Copper base design, 1/8" dimples driled into the 1/4" thick bar with channels connecting most holes (the copper pipe on the inlet fits over the dimple array).
Completed block epoxied together.
Currently, with one 92mm fan running I'm getting about 45*C load, but then again the AS5 has had no time to set in, and I'm at my school's lan party where it's been pretty warm so far for this time of year. I'll post more pics for any requests for specific pics.
Components:
Kustom block
19?? Escort heatercore w/ shroud for 2x92mm
Eheim 1048, run submersed
5 gallon bucket reservoir
About 8' 1/2"id-3/4"od Home Depot vinyl tubing + 2 feet POS 1/2"id-5/8"od "kink-for-sure" vinyl
1 3/4" gallon distilled h2o, with a spa biocide tablet
Lotsa hoseclamps, zipties, ~1 1/2 tubes 5 minute epoxy, some amount of my blood and sweat
Now for the pics:
Completely kustom block:
Inside with impingement center inlet and 2 outlets
Copper base design, 1/8" dimples driled into the 1/4" thick bar with channels connecting most holes (the copper pipe on the inlet fits over the dimple array).
Completed block epoxied together.
Currently, with one 92mm fan running I'm getting about 45*C load, but then again the AS5 has had no time to set in, and I'm at my school's lan party where it's been pretty warm so far for this time of year. I'll post more pics for any requests for specific pics.
Last edited: