DIY USB IR receiver parts assistance

i want to make this IR reciever

http://www.ocinside.de/go_e.html?/h...r_receiver.html

heres the parts list:

1x Vishay TSOP 1738
1x Atmel AT90S2323-10

1x 8-pin IC-Socket
1x 12MHz quartz
1x 4.7µF / 16 volt capacitor (Elko or Tantal) vertical construction
1x 10µF / 16 volt capacitor (Elko or Tantal) vertical construction
1x 100nF capacitor (ceramik, layer or multilayer) vertical construction
1x 1.5 K resistance (0,25 watt)

1x Printed circuit board (PCB); approx. 5 cm² is sufficient
1x USB A-plug male

the first 2 and the last 2 aren't a problem, but when i try to find the socket, crystal, capacitors, and the resistor i'm drowned in a sea of search results. can someone help me wade through? or at least give me some keywords that would help...

i was looking at mouser, but if there are better places feel free to link.

thanks

Look what I found at mouser...
8 pin IC socket
12mhz quartz
1x 4.7µF / 16 volt capacitor radial lead
1x 10µF / 16 volt capacitor radial lead
100nf capacitor
1.5k OHM 1/4watt resistor axial lead

They sent me their 2-inch-thick print catalogue last week.

thanks

edit: the socket and the 100nf are oos or i can't order just one.

Here are some alternate 8pin IC sockets on mouser:
http://www.mouser.com/index.cfm?han...uctid=208342&e_categoryid=602&e_pcodeid=53501
http://www.mouser.com/index.cfm?han...uctid=223114&e_categoryid=602&e_pcodeid=57501

I found packs of 100nf capacitors on ebay.
http://cgi.ebay.com/100NF-100v-Radi...ryZ40113QQssPageNameZWD1VQQrdZ1QQcmdZViewItem