Mixing Epoxy

[Genis B]

i cannot find any stores in Melbourne that sells ASII so i decide to buy some epoxy just for the moment. and here we are i bought a pack of two epoxy glue, part A contains 100ml/L Amine and the second one part B contains 1000ml/ L Liquid Epoxy Resin. and here is mine queation:
Do i have to mix them to make it stick and if i do , what amount of each do i need is the best?
does this setup have er.... conducting heat ability?
i need to apply this to the M/B chipset so it will hold mine mini Borb.
but do i need any on mine new Volcano 6 cu+? or the silicon compund that come with it is good enough?
i am so sh$$ @ chemistry, so just wondering what happen if i mix the silicon with these? will it do any good for conducting heats and also hold the fans strongly?


any help would be appricate.

[-Exi|e-]

Dont put that epoxy between ur chipset or your heatsink:eek: It will probly be worst than what you have now for you chipset, normal epoxy is not quite thermally conductive so it could damage your system if you did that. Try to get ASII if you can its the best, order it online, whatever you do dont put that in between! As for your heatsink, that thermal compound should suffice...

[r0ckstarbob]

http://www.techpatrol.com.au/2001pages/productspecs/adhesives_solvents.htm

there ya go. a store in melbourne that sells arctic silver II.

all i did was punch in the words "Melbourne Arctic Silver" into the Google search engine and hit GO and there it was.

[r0ckstarbob]

your other option is to find some thermal epoxy. theres several brands out there, you just have to look. the search engine is a good place to start.

[Genis B]

thanks for the link.

[r0ckstarbob]

anytime brotha