Question about OverClocking - Please Look

[FluidHosts]

Ok,

I overclocked my System to 11.5x213 and it is Stable. I need to know what to set the ram settings to volt only goes to 2.8. What the default is 8332.5. Please let me know. I have it set at 6332.5 right now. What should i have it at

asking about the Ram thing. My computer Drags some times. I think it is because of the ram settings.

[Avg]

Read over what you wrote, it's kind of hard to understand, is the ram rated to run a 2.5 3 3 8 timmings at 200mhz? And you are running it at 2.5 3 3 6, if so there isn't much of a difference, if your worried that your ram is not stable eun memtest86, if you want to make your timming tighter, just lower the numbers and run memtest and see if there is any errors, and if you experience unstability increase the voltage.

[FluidHosts]

Read over what you wrote, it's kind of hard to understand, is the ram rated to run a 2.5 3 3 8 timmings at 200mhz? And you are running it at 2.5 3 3 6, if so there isn't much of a difference, if your worried that your ram is not stable eun memtest86, if you want to make your timming tighter, just lower the numbers and run memtest and see if there is any errors, and if you experience unstability increase the voltage.

Was trying to see what would be better i am 2.5335 right now and the default is 2.5338

[avalanche83]

Try running a Everest with 2.5-3-3-8 then try it at 2.5-3-3-5 and see if there is any difference.

(edit) I just ran two instances one with 2.5-3-3-8 and the other with 2.5-3-3-5 and it had no affect whatsoever on latency. Both where 45.3ns.