AMD K6/2 oc help

[elfboy999]

Ok i posted about 2 weeks ago asking how to oc mt CPU and using SoftFSB and CPUFSB were suggested. neither worked for me. Also finding the clock multiplier settings printed on the motherboard was suggested. I did that. and attached a picture with this post of what it looked like.

Now what do I do now that I found it. Is there jumpers i have to locate or...

[WillysNut]

If you look at the diagram, and then look at your motherboard (with a good light), you should see two rows of pins sticking up from the board w/ plastic bases.

The row on the top is for the multiplier of the cpu. You want to locate small plastic jumper covering one of the set of pins. That plastic piece what you move to change the multiplier up or down.

I'm not sure what the bottom row is based on your attached drawing but you want to use the top row for overclocking purposes. Move the pin's from left to right or vice-versa to adjust..not up and down. See attached. Be sure you have proper cooling or run w/ your case open for testing purposes.

Hope this helps..good luck!

[elfboy999]

Well i looked in my system and sadly only found 3 sets of jupers 2 of which control between passive and powered speakers and the 3rd i dunno but i didn't look important...

poop...

[elfboy999]

ok IBM (the ********) finaly returned my emails and sent pe a pic of switch settings used in the clock multipliers. So i have attached that very pic. I tried right away at pushing it up to 5.5*100 but my moniter would't turn on. It was like it was in standby or somethin. Do i need to up the voltage. I tried putting it upto 2.4 but to no avail then again that just might not be high enuff. Im scared to putting it any higher cuz this is the only pc i got till my Shuttle ak31 comes for my new one. so i thought i would ask first.

BTW on the picture of the voltage settings the one with the star next to it is the default.