Need a little help with wiring lights

[Silver]

As many know, I am pretty much using my oc'd boxes for folding 24/7. Problem is the wife is not too keen on the cases all over the living room. Thus I find myself building a ten mobo case to hold them all. Won't go into the specifics at this time but am looking for a little help with a couple of small things. Figure momentary switches from rat shack will take care of the on/off duties but am not sure on a power light and a hard drive light. I would like to put these two lights on each layer and am not sure as too which lights, resistors or what not that might be necessary. Access to a rat shack is readily available but could use a little assistance in 'getting it right'. Figure to plug these lights into the mobo on each layer.

[johnny5c]

You can use standard 5mm LED's running of the mobo's power and HDD headers without a resistor. I checked the voltage of my asus board and it was 1.8V so a LED rated at 1.7T & 2.4 max works just fine. To make is easier, you could strip the power LED and HDD wires out of the old cases so you don't have to buy any connectors.

[Silver]

Thanks guys, was not sure on the voltage or the proper wiring. That should do the trick. Thanks again.