PDA

View Full Version : Cpu doesnīt post again!

tacobell
10-27-01, 11:16 AM
I bought another cpu, this time a tbird 1GHz axia y 200FSB.

It was pre-tested at 1.5. I started for the first time, all normal, then I changed to 133x9, reinitiate and nothing, set all to default, 10x100, it locked inside bios, now it wonīt post..

What is happening here?
tacobell
10-27-01, 11:56 AM
up
Kendan
10-27-01, 12:07 PM
Try to clear the cmos. Then go into bios and change it to non overclocked settings. make sure everything is stable. Then overclock in small increments. I hope this helps.
tacobell
10-27-01, 02:42 PM
already tried... a7v133 resets to default setting when it doesīt post... anyway, i put all defaults by jumper, cleared cmos, took of battery... still doesīt post.
Kendan
10-27-01, 02:55 PM
Was it unplugged from the wall when you cleared the cmos?
tacobell
10-27-01, 05:08 PM
yes
Fiz
10-27-01, 05:19 PM
How long did you run it before you set it to 9X133? Are there any beeps from bios or anything? Did you check the HSF? Just some things to think about. Sounds like a fried CPU.

Fiz
tacobell
10-27-01, 07:28 PM
my brother didnīt wanted any time, on the first boot he set it to 9x133 but iīm pretty sure the hsf was working.. and i checked the core after and it was normal...

Just on bep... the normal one when itīs all ok.
Fiz
10-27-01, 10:04 PM
Do you have access to another CPU to try in the mobo or can you try the chip in a different mobo? That way you can rule out one or the other. What chipset does your mobo have, if it's a KT133 the 133 mhz fsb is where your problem is. It really sounds like the cpu overheated, they can be rather deceptive as far as visually telling whether or not it fried. There also may be a crack in the core from when you put the HSF on.

Fiz