- Joined
- Dec 19, 2005
- Location
- New York
Most of you are probably well aware of my recent Project "Brain Freeze" WC setup and article. If not it can be viewed here: http://www.strippoli.com/water/
or here: http://www.ocforums.com/showthread.php?t=437178
My question today is for members experienced in dual pump setups. Because I will be fabricating an external enclosure for my pump/res/radiator the total amount of tygon 1/2 ID tubing used for my project exceeded 12 feet in length. I read somewhere that my D5 pump is theoretically maxed out at a 10 foot tubing length.
Do you guys think I would benefit in flow-rate and a few degrees temperature drop by ordering another D5 pump and installing it right behind the other in a series?
Thanks in advance.
Dom
or here: http://www.ocforums.com/showthread.php?t=437178
My question today is for members experienced in dual pump setups. Because I will be fabricating an external enclosure for my pump/res/radiator the total amount of tygon 1/2 ID tubing used for my project exceeded 12 feet in length. I read somewhere that my D5 pump is theoretically maxed out at a 10 foot tubing length.
Do you guys think I would benefit in flow-rate and a few degrees temperature drop by ordering another D5 pump and installing it right behind the other in a series?
Thanks in advance.
Dom