3.2 on 3.3 line ok?

[Nexus Realized]

I've noticed that my PSU is staying steady at 3.2v on it's 3.3v line according to speedfan.
Is that acceptable enough to not create any problems?
PSU is an OCZ Powerstream 520.

[Know Nuttin]

it's fine, assuming speedfan is accurate. Are all the led's on the back of the PSU green?

you really should use a DMM to measure with and not software.

[LordDarik]

it's fine, assuming speedfan is accurate. Are all the led's on the back of the PSU green?

you really should use a DMM to measure with and not software.
Agreed, if you want to really check your voltages than go to your local hardware store and buy a digital multimeter. They ussualy cost around $20 for a nice one to use on your PSU.

[Nexus Realized]

Yeah all 3 lights are green.
I'll have to pick up a DMM to make sure what they are at.
The rail adj. still have the sticker over it, I always just assumed it was shipped with them cranked up. I'll give that a look into also.

[Pntgrd]

Nexus, my new OCZ 520w is showing 3.264 on the 3.3 also. All the lights on mine are green, too. I will check mine here sometime with my DMM when I get a chance. Looks like the nature of them to read a bit low.