thermoengine - clip pressure on Xp

[peppy]

Is there going to be enough clip pressure on a thermoengine with delta fan for an athlon Xp to work properly?
it says on the box 19+- 3 pds. my mobo is an iwill kk266

also off the subject - sorry
what is the multiplyer for a locked athlon 1600
or 1700?

[Intraveinous]

It should be. They worked OK on everything else. If you're worried about it, put a layer of ASII on the chip and then put the heatsink on, take it off and see if it made a good imprint on the heatsink bottom.
On Multipliers, the XP1600 is 10.5 x 133 and the XP1700 is 11 x 133.
Peace
John

[peppy]

Thank you very much

[peppy]

another question: would a delta 50 cfm fan cool better than a delta 38cfm fan, alot i mean by like 3degrees or more?