mw521
11-05-01, 03:23 PM
Using air line quick connects on your water cooling system? Don't you just hate it when you disconnect and have to drain one end?
Try this, just put two male connectors together like this and use two females on your unit. When you disconnect just snap both ends at same time and drop this part out. You will lose much less coolant and have a check valve on both ends. Practice a little before you snap them off as if you leave one end in and don.t get the other it will be an open line!;)
Try this, just put two male connectors together like this and use two females on your unit. When you disconnect just snap both ends at same time and drop this part out. You will lose much less coolant and have a check valve on both ends. Practice a little before you snap them off as if you leave one end in and don.t get the other it will be an open line!;)