- Joined
- Dec 4, 2005
Alright well i was uber juiced about getting my h20 parts today so I went ahead and started assembling it, but then i realized that when i turned it on everything went to crap. Water was leaking all over the place, from the outlet of (via aqua 1300 pump) and the arrangment of the tubing was terrible without any preparation and done w/ stupidty causing them all to get tangled. And because of this, when i was twisting off the inlet of the pump, i broke a plastic piece that kept the (impeller?) is the door basically to the blue thingy inside the pump. Well the broke the piece and now it pops open whenever i fiddle w/ the tubing.
On the plus side:
120x2mm heatercore doesn't seem to b leaking
Zalman WB2 cpu block doesn't leak
D-tek Reservoir doesn't leak (and took me a while to realize it was better to just plug in the tubing on the same side instead of separating by side.)
So my question is am I screwed? Can my dreams of watercooling b saved???
On the plus side:
120x2mm heatercore doesn't seem to b leaking
Zalman WB2 cpu block doesn't leak
D-tek Reservoir doesn't leak (and took me a while to realize it was better to just plug in the tubing on the same side instead of separating by side.)
So my question is am I screwed? Can my dreams of watercooling b saved???
Last edited: