pal6035 on xp1600?

[kimber]

its that time of year to upgrade for me.im looking at the epox kt266a mb with a 1600 xp.of coarse i'll be cranken her alittle bit. but im tring to keep costs down alittle so i was hopeing to get away with using my pal6035 on the xp.i was even thinking about throwing a 80mm fan on it with an adaptor.anyone know anyone who tried this combo?or if this should work?
also would the retail xp hs work on my p3 700?

[cowanrg]

dont know how much overclocking you are planning on doing, but i currently have my old PAL6035 on my 1800+ chip, with a mild overclock to 1626mhz... it runs a little warm (48C FULL load...), but thats with 1 cheapo case fan, and THATS it. if you have even horribly ventilation in your case, you will have better temps than me.

[el]

they retail xp hs should work for the p3-700 cuz I think it will fit but you should double check the make of the hs and then post that question cuz I heard they might be shipping different hsf with the xp retail chips.

[kimber]

******* if you have even horribly ventilation in your case, you will have better temps than me *******

well i have a modded tornado 1000 case so i think that should be fine.

[cowanrg]

exactly...

and i have a 500-watt PSU that heats up pretty darn good...

the PAL6035 isnt the best out there, but its definately good enough for a 1600.