going for more!

[Jeff Bolton]

i'm gonna go for 1350 mhz with temps under 125-130 load if i'm lucky, if not i'm not gonna worry about it. i'll tell you guys how it turns out in a little while.

[Jeff Bolton]

awesome! after many restarts and tweaks i got it up to 1367 mhz and full load running F@H is only 120°. had to up the vcore from default to 1.825v. i'm thinking this is going very stable. not too bad for almost 200mhz over clock speed. i'm learning a lot from you guys!

[JAWS]

Nice o/c!:) You can't increase your vcore to 1.85. What stepping is your 1.2?

[Jeff Bolton]

i don't know, where do i find that at? i'm just going by what the bios said. i said 1.825v...so i don't know. tell me where to find the stepping and i'll tell you.

jeff

[JAWS]

It on the top of your chip! It's important, but not that important. If you don't mind removing your hs/f, than go ahead!:)

[Warlord2]

are you using mbm?

if so that will tell you your exact vcore

some tbirds overclock better thin others and you can see if they overclock well if they have a good stepping code

I have a AXIA stepping code wich are awesome and I was able to post a 1.2@1.6 but I need to do a voltage mod for it to be stable

some tbirds just wont overclock at all so looking up the stepping code is a easy way for you to see how well it will overclock

[Jeff Bolton]

ok thanks, i'll check it out if i get bored tomorrow

jeff

[Jeff Bolton]

does this help? (with the stepping)

jeff