Pc-2700

[thehandler]

Help, I need to find right away, some DDR PC-2700, 333mhz, cas 2, 2.7gig transfer rate memory and I need to find it now. Is there anyone who knows where I can find this memory or if anyone is making it yet? Mike

[abb1]

I dont think it is out yet. There are a lot of people waiting for it, so it will be in high demand.
Abb

[thehandler]

Micron has it listed on their site with a part number and the whole shot but I cannot find it retail yet and Micron will not answer my inquiries as to when it will be out in the retail channels. Mike

[Placid]

Here is a link to what you can buy now.

http://www.pricewatch.com/1/33/4131-1.htm

Its probably all just 2100 memory thats been tested to run at 2700 thou.

[jbell]

Originally posted by Placid
Here is a link to what you can buy now.

http://www.pricewatch.com/1/33/4131-1.htm

Its probably all just 2100 memory thats been tested to run at 2700 thou.

No Micron has released OFFICIAL PC2700 Ram

as far CAS and transfer rates I dunno

[chaosdriven]

There is also this....
http://dtekcustoms.safeshopper.com/11/46.htm?616

[TRANCER24]

Originally posted by chaosdriven
There is also this....
http://dtekcustoms.safeshopper.com/11/46.htm?616

I think that is just a waste of money my 256 meg stick of pc 2100 Crucial will do 170 fsb at cas 2 and i only paid 34 bucks for it.

[thehandler]

Thanks Trancer,
You are right. In fact, I just ordered and received a stick of Crucial 256 DDR 2100 for that very reason. I also have a new Epox 8KHA+ on order. I am going to stick my Duron 600 in it temp. just until the prices come down a bit more on the XP. I can only hope I can achieve similiar numbers to what you have with this combination. I would be very happy to achieve 900-1gig. Did you have to do any voltage mods to your board or was 1.85 enough to run the Duron stable? Thanks Mike

[TRANCER24]

Originally posted by thehandler
Thanks Trancer,
You are right. In fact, I just ordered and received a stick of Crucial 256 DDR 2100 for that very reason. I also have a new Epox 8KHA+ on order. I am going to stick my Duron 600 in it temp. just until the prices come down a bit more on the XP. I can only hope I can achieve similiar numbers to what you have with this combination. I would be very happy to achieve 900-1gig. Did you have to do any voltage mods to your board or was 1.85 enough to run the Duron stable? Thanks Mike

No i didn't do any voltage mods there is no need to do a volt mod with the 8k7a MoBo unless you wanna go above 2.20 volts vcore. With the 8Kha+ board you have just purchased you will need to volt mod it to get these voltages. I have mine at 2.13 in the bios i still could go a notch higher even. But what i did do was close my L7 bridges that was necessary to get this also. Good Luck