Please help me!! Celeron 1200@1464

[tron.alessio]

hi,
i am a italian navigator of the web and your site.
could you please tell me what i must do to increase the voltage higher 1.675V with my ASUS TUSL-2C, it's impossible to do it in the bios. maybe, would i change my mother board? i know what i am risking....sorry for my bad english, but, please, answer me!! thank you bye bye

Alessio

[Sklathill]

All you have to do is connect VID1 and VID2 together. Check out http://www.hardocp.com/articles/intel_stuff/bumpvoltage.html for a similar procedure.

[ol' man]

Originally posted by Sklathill
All you have to do is connect VID1 and VID2 together. Check out http://www.hardocp.com/articles/intel_stuff/bumpvoltage.html for a similar procedure.

No the pins are different now, you have to connect different ones to achieve the higher voltages. Here is a url to help you.

http://developer.intel.com/design/celeron/datashts/298596.htm

You are concerned with page 21 and 60 I believe.

[Sklathill]

Er...I said a similar procedure, not the exact procedure. If you connect VID1 to VID2, as I said above, you'll get a default voltage of 1.675.

[ol' man]

Yeah, sorry about that you are right it is vid 1 and 2 connected. These data sheets will tell you where they are. I am dealing with a 1.375 defualt vcore with my chip;) I accidently ripped out vid 1:) It allows me to go higher with my default vcore.

[ol' man]

Anyword on this yet or what dude?