Can't get PIII 933 past 700-help

[Diggar]

I have a P2B-F board. I udated the bios and have an Asus slocket. I bought a 933MHz PIII FC-PGA (sl52q). The board boots fine leaving the slocket at the default setting.

No matter what I try I cannot get it above 700MHz. I have tried 1.8v on the slocket and it just sits at 700.

Thanks

[saytan]

you need to set the FSB to 133

[Yodums]

I think you have to set the slotket it doesn't set itself me thinks..

Check the manual for it.

[jazztrumpet216]

Could be the board too. Those BX chipsets don't TECHNICALLY support a 133 Mhz FSB (though they do have a setting for it). Check the slotket for jumpers, but if that fails, just use the set on the motherboard. When I was using a slotket on a P2B-B, I didn't have jumpers on the slotket except for the ones that changed the Vcore, so I HAD to do it from the motherboard.

[Yodums]

Try setting the slotket to 133 fsb and..

Then see if it boots..

The slotket should be doing the job really but about the BX chipset.. Hmmm ;/